Notes And Warnings; Equipment Identification - IARP GLOBO RETRÒ Série Instructions D'emploi Et D'entretien

3. NOTES AND WARNINGS

The content of this manual is technical and the property of EPTA s.p.a. It is forbidden to reproduce,
distribute or modify entirely or partially its content without written authorisation.
The owner company safeguards its rights pursuant to legislation in force.
The company cannot be held in any way liable for any damage to people, animals or the product conserved in the event of:
• Improper use of the equipment or use by unsuitable or unauthorised staff.
• Non-compliance with the standards in force
• Incorrect installation and/or faulty power supply
• Non-compliance with this manual
• Non-compliance with the maintenance program
• Unauthorised changes
• Installation of non-original spare parts on equipment
• Installation and use of the equipment for purposes other than those characterising design and sale
• Tampering with or damage to the power supply cable
Responsibility for application of the safety provisions outlined below is the responsibility of the technical staff
responsible for the activities planned on the equipment, who must ensure the authorised staff:
• Are qualified to perform the task requested
• Know and strictly comply with the provisions contained in this document
• Know and apply the general safety standards applicable to the equipment
Tampering with or unauthorised replacement of one or more parts of the equipment, use of accessories that
change its use and use of spare parts differing from those recommended can cause risks of accidents.
Any intervention on the equipment strictly requires disconnection of the power socket and however no guard
(grids, casings) should be removed by unqualified staff; strictly avoid operating the freezer with these guards
removed.

4. EQUIPMENT IDENTIFICATION

• Located on the plate affixed to the machine to detect the technical data.
• Check the model and power supply voltage before carrying out any operation.
• If discrepancies are found, immediately contact the manufacturer or the company that supplied the equipment.
1. Manufacturer
2. Code
3. Conformity marking
4. Power supply voltage (V)
5. Power supply frequency (Hz)
6. Absorbed electrical power (W)
7. Absorbed electrical power in
defrosting (W)
8. Light max. power (W)
9. Gross volume
10. Type and quantity of refrigerant
11. Climate class
It is strictly forbidden to remove, tamper with the plate and change or alter the data
contained in it.
1
5
4
7
8
6
11
9
3
Example of data plates
*
2
10
11
-20-