Programming - Abus FUBE50060 Instructions D'installation

8. Programming

Press the program button (15) to enter program mode. The program mode
consists of 6 submenus.
1. Operating mode
2. beep tones
3. User code
4. time
5. Partition
6. Learn mode
Press the program button (15) repeatedly to access the desired submenu.
Program mode is exited at all menu levels after about 2 seconds if the
program button (15) is not pressed.
Activate submenus or learn mode by pressing the program button (15) and
keeping it pressed. This is confirmed by the display of a
select either
operation as an arming station (FU5140) and
wireless info module (FU8200), or
operation as a 2WAY arming station (FU8110)
(see chapter 8.1.)
activates/deactivates the signal tones on the
wireless key switch (see section 8.2.).
defines the user code (see section 8.3.)
You can change the reception time of the wireless
key-switch here (see section 8.4.)
defines the partitions that are assigned to the
wireless key switch and for which the user has
authority (see section 8.5.) (for operating mode 1
only)
for training your wireless alarm system to work with
the wireless key switch. This enables you to view
the active or idle state of your wireless alarm
system (see section 8.6.2) (for operating mode 1
only).
28
.