Contents; Note The Following Before Starting - Husqvarna 323E Série Manuel D'utilisation

Contents

KEY TO SYMBOLS
Symbols ................................................................ 27
CONTENTS
Contents ............................................................... 28
Note the following before starting: ........................ 28
INTRODUCTION
Dear customer! ..................................................... 29
WHAT IS WHAT?
What is what? ....................................................... 30
GENERAL SAFETY PRECAUTIONS
Important .............................................................. 31
Personal protective equipment ............................. 31
Machine's safety equipment ................................. 32
ASSEMBLY
Fitting the loop handle .......................................... 36
Assembling the angle gear ................................... 36
Assembling the cutting equipment ........................ 36
Assembling the blade ............................................ 36
FUEL HANDLING
Fuel safety ............................................................ 38
Fuel ....................................................................... 38
Fueling .................................................................. 39
STARTING AND STOPPING
Check before starting ............................................ 40
Starting and stopping ............................................ 40
WORKING TECHNIQUES
General working instructions ................................ 42
Basic working techniques ..................................... 43
MAINTENANCE
Carburetor ............................................................. 44
Muffler ................................................................... 44
Cooling system ..................................................... 45
Spark plug ............................................................. 45
Air filter .................................................................. 45
Angle gear ............................................................ 46
Lubricating the flexible drive shaft ......................... 46
Adjusting the edger's cutting depth ....................... 46
Maintenance schedule .......................................... 47
TECHNICAL DATA
Technical data ....................................................... 48
FEDERAL AND CALIFORNIA EMISSIONS
CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS 50
28 - English
CONTENTS
Note the following before
starting:
Please read the operator's manual carefully.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
!
!
!
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal and Californian emissions requirements.
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
WARNING! Long-term exposure to noise
can result in permanent hearing
impairment. So always use approved
hearing protection.
WARNING! Under no circumstances may
the design of the machine be modified
without the permission of the
manufacturer. Always use genuine
accessories. Non-authorized
modifications and/or accessories can
result in serious personal injury or the
death of the operator or others.
Your warranty may not cover damage or
liability caused by the use of non-
authorized accessories or replacement
parts.
WARNING! An edger can be a dangerous
tool if used incorrectly or carelessly, and
can cause serious or fatal injury to the
operator or others. It is extremely
important that you read and understand
the contents of this operator's manual.
11535649-32 Rev. 5 2014-12-02