Candy CPDC 451 Mode D'emploi page 42

4) Remove the central hinge.
5) Remove the bottom door.
6) Remove the plastic membrane covering the top left hinge and the lower left hinge from
the panel and the plinth.
7) Remove the pin (B) from the bottom right hinge and reassemble on the left.
8) Remove the pin (C) from the top right hinge and reassemble it on the left. Models with
the upper tall door (fig. 7c – inside upper portion of the top door ), remove caps F-G, pivot
D and the right upper hinge, taking away the screw. Take the left upper hinge (H) from
plastic bag and fix it with the screw you have removed. Fix pivot D with washer to the left
upper hinge. After transferring the hinge to the left hand side, the plastic insert (L) which
covers this mechanism needs to be altered, the membrane of cap G needs to be broken
so that its fits back into place.
9) Refit the doors in the reverse order (5-4-3-2) and remember to also fit the spacer
washers, if they are available.
10) Move the vertical handles, if they have been supplied, from the left hand side to the
right hand side, by adjusting the relevant screws. For handles marked "M", move them
diagonally across from left to right. Remove the adhesive label from the left handle, take a
new label from the accessory pack, remove the protective strip and attach it to the right
handle.
11) Restore the appliance to the upright position.
HOW TO PANEL THE 370 L - 410 L REFRIGERATOR
Dimensions of insert panel (see fig. 11):
370 L
freezer door
refrigerator door
410 L
freezer door
refrigerator door
Necessary tools: Philips screwdriver.
Procedure:
a) Remove the frame form the freezer door, unscrewing the screws on the right-hand side
of the door.
b) Loosen the top and bottom screws.
c) Insert the panel in the appropriate opening in the frame.
d) Refit the frame, tightening the screws, tighten the top and bottom screws.
The procedure for the larger door is the same.
IF THE LIGHT IN THE REFRIGERATOR'S COMPARTMENT DOES NOT WORK, PRO-
CEED AS FOLLOWS:
- Disconnect the appliance from the mains.
- Remove the protection lid, unhooking it from its positions (in models with ceiling light pull
forward and downward; in models with side light push the lower side and move upward).
- Unscrew the bulb and replace it with a similar one.
- Replace the cover and reconnect the appliance to the mains.
42
Height Width
mm.
709
976
709
1134
Thickness
mm. mm.
588 3 max
588 3 max
588 3 max
588 3 max