Pre-Operation Check - Honda Power Products TILLER F560 Manuel De L'utilisateur

Place the tiller on a firm level surface and hold the tiller level (i.e. with
the tires, rotary tines and drag bar). Stop the engine before starting
service of the tiller. Servicing the tiller on an unstable surface of the
ground or without stopping the engine can cause injury and/or
equipment damage.
Daily inspection and service of tiller is essential for safe and reliable
operation. Perform the following check before operation.
1. Tiller outside
Aren't the fuel and engine oil leaking?
Isn't there any flammable material (dust, straw, etc.) around the
engine?
2. Control lever function
Does the lever operate smoothly?
Is there the specified amount of freeplay at the tip of the lever (see
pages 47 and 48
3. Wiring and cables
Isn't the insulation of each wire and cable torn or cut?
Is there any wire or cable pinched by the neighboring parts?
4. Engine operation
Start the engine. Is there any abnormal sound from the engine? (See
pages 20 and
Does the engine stop securely by operating the engine switch? (See
pages 34 through
If you notice any other abnormal symptoms, consult with your
authorized Honda dealer promptly.
5. Bolts and nuts
Check for looseness in fastened parts. Securely tighten all loose
parts.
)?
21 for starting procedure.)
36 for stopping procedure.)
4.

PRE-OPERATION CHECK

13