Bosch GLM 100 C Professional Notice Originale page 30

OBJ_BUCH-1956-002.book Page 30 Monday, July 1, 2013 11:28 AM
30 | English
Cause
Battery charge-control indicator (g) and "ERROR" indi-
cation in the display
Battery charging voltage not cor-
rect
Bluetooth® cannot be activated
The battery is too low.
No Bluetooth® connection
Failure of the Bluetooth® connec-
tion
Data transmission via USB interface not possible
Software error
Micro USB cable
2 609 141 026 | (1.7.13)
Corrective Measure Cause
Battery charge-control indicator (g) or prolonged charge
duration indication n on the display
Check if the plug-in con- Charge duration clearly too long,
nection has been estab- as charging current too low.
lished correctly and if
Measuring result not plausible
the battery charger is
The target surface does not reflect
operating properly.
correctly (e.g. water, glass).
When the unit symbol is
The laser beam outlet 18 or the re-
flashing, the battery is
ception lens 17 are covered.
defective and must be
replaced by a Bosch af-
ter-sales service.
Wrong reference level set
Charge the measuring
tool's battery.
Obstruction in path of laser beam Laser point must be
Check the application on
your mobile termi-
The indication remains unchanged or the measuring tool
nal/device.
reacts unexpected after pressing a button
Check if Bluetooth® is
Software error
activated on your meas-
uring tool and mobile
terminal/device.
Check your mobile ter-
minal/device for over-
load.
Reduce the distance be-
tween measuring tool
and your mobile termi-
nal/device.
Avoid obstructions
measuring tool checked by an after-sales service agent for
(e.g., reinforced con-
Bosch power tools.
crete, metal doors) be-
tween measuring tool
Maintenance and Service
and your mobile termi-
nal/device. Observe
Maintenance and Cleaning
clearance to electro-
magnetic disturbances
Store and transport the measuring tool only in the supplied
(e.g., WLAN transmit-
protective pouch.
ters).
Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other fluids.
Make sure that the soft-
Wipe off debris using a moist and soft cloth. Do not use any
ware runs correctly on
cleaning agents or solvents.
your computer or note-
Maintain the reception lens 17 in particular, with the same
book. For further infor-
care as required for eye glasses or the lens of a camera.
mation, please refer to
In case of repairs, send in the measuring tool packed in its
the Bosch website at
protective pouch 26.
www.bosch-pt.de
Check the proper and
After-sales Service and Application Service
tight seating of the micro
Our after-sales service responds to your questions concern-
USB cable.
ing maintenance and repair of your product as well as spare
Check the micro USB ca-
parts. Exploded views and information on spare parts can al-
ble for damage.
so be found under:
www.bosch-pt.com
Corrective Measure
Only use the original
Bosch charger.
Cover off the target sur-
face
Make sure that the laser
beam outlet 18 or the re-
ception lens 17 are un-
obstructed
Select reference level
that corresponds to
measurement
completely on target
surface.
Press the measuring
button 2 and the button
for clearing the internal
memory / On/Off 4 to re-
set the software.
The measuring tool monitors the correct
function for each measurement. When a de-
fect is determined, only the symbol shown
aside flashes in the display. In this case, or
when the above mentioned corrective
measures cannot correct an error, have the
Bosch Power Tools