Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch LR 1 Professional Notice Originale

OBJ_DOKU-27392-004.fm Page 19 Thursday, December 17, 2015 4:56 PM
Attaching with the Holder (see figure A)
With the holder 17, the measuring tool can be fastened to a construction laser measur-
ing rod 15 (accessory) as well as to other auxiliary tools with a width of up to 65 mm.
– Screw the holder 17 to the retainer opening 12 on the rear side of the measuring
tool with fastening screw 16.
– Loosen the locking screw 13, slide the holder onto the construction laser measur-
ing rod 15, for example, and retighten the locking screw 13.
The upper edge 14 of the holder is located at the same height as the centre mark 5
and can be used for marking of the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the measuring tool can be
attached to steel parts via the face side using the magnet plate 4.

Maintenance and Service

Maintenance and Cleaning

– Keep the measuring tool clean at all times.
– Do not immerse the measuring tool in water or other fluids.
– Wipe off debris using a moist and soft cloth. Do not use any cleaning agents or sol-
vents.

After-sales Service and Application Service

Our after-sales service responds to your questions concerning maintenance and re-
pair of your product as well as spare parts. Exploded views and information on spare
parts can also be found under: www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning our prod-
ucts and their accessories.
In all correspondence and spare parts orders, please always include the 10-digit arti-
cle number given on the nameplate of the product.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Bosch Power Tools
English | 19
1 609 92A 275 | (17.12.15)