Getting Started; Remove The Packaging; Clean Before Using; Water Supply Requirements - Jennair EDR3RXD1B Guide D'utilisation Et D'entretien

GETTING STARTED

REMOVE THE PACKAGING

Remove tape and glue residue from surfaces
before turning on the refrigerator. Rub a small
amount of liquid dish soap over the adhesive
with your fingers. Wipe with warm water and
dry.
Do not use sharp instruments, rubbing
■
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These
products can damage the surface of your
refrigerator. For more information, refer
"Care and cleaning."
Dispose of/recycle all packaging materials.
■

CLEAN BEFORE USING

After you remove all of the packaging materials,
clean the inside of your refrigerator before
using it. Refer the cleaning instructions in "Care
and cleaning ."
Important information to know about glass
shelves and covers:
Do not clean glass shelves or covers with warm
water when they are cold. Shelves and covers
may break if exposed to sudden temperature
changes or impact, such as bumping. Tempered
glass is designed to shatter into many small,
pebble-sized pieces. This is normal. Glass
shelves and covers are heavy. Use both hands
when removing them to avoid dropping.
10 | GETTING STARTED

WATER SUPPLY REQUIREMENTS

Read all directions before you begin.
IMPORTANT:
When your refrigerator was installed,
■
the water connection from the water
source should have been connected to
your refrigerator. If your refrigerator is
not connected to a water source, refer
"Connect to Water Line" in the Installation
Instructions. If you have any questions
about your water connection, refer
"Troubleshooting" or call a licensed,
qualified plumber.
If you turn the refrigerator on before the
■
water line is connected, turn the ice maker
OFF. Refer "Ice Maker and Storage Bin."
All installations must meet local plumbing
■
code requirements.
Connect to potable water supply only.
■
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable
cysts.
WATER PRESSURE
A cold water supply with water pressure
between 30 psi and 120 psi (207 kPa and 827
kPa) is required to operate the water dispenser
and ice maker. If you have questions about your
water pressure, refer "Troubleshooting" or call a
licensed, qualified plumber.
NOTE: If the water pressure is less than what
is required, the flow of water from the water
dispenser could decrease or ice cubes could
be hollow or irregular shaped. If you have
questions about your water pressure, call a
licensed, qualified plumber.

REVERSE OSMOSIS WATER SUPPLY

IMPORTANT: The pressure of the water supply
coming out of a reverse osmosis system going
to the water inlet valve of the refrigerator needs
to be between 30 psi and 120 psi (207 kPa and
827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 40 psi (276 kPa).
If the water pressure to the reverse osmosis
system is less than 40 psi (276 kPa):
Check to see whether the sediment filter
■
in the reverse osmosis system is blocked.
Replace the filter if necessary.
Allow the storage tank on the reverse
■
osmosis system to refill after heavy usage.
If your refrigerator has a water filter, it may
■
further reduce the water pressure when
used in conjunction with a reverse osmosis
system. Remove the water filter. Refer
"Water Filtration System."
If you have questions about your water
pressure, call a licensed, qualified plumber.