EUROM Fly Away 30-2 IPX4 Manuel D'utilisation page 9

The insect-killer can be suspended from the chain or placed on a surface such as a table or
4.
cabinet. Make sure it is on a good stable base.
Install your insect-killer in a relatively dark place , near an electricity socket: not in direct
5.
sunlight (windows, doors), because bright sunlight weakens the insect-killer's radiation
power. Artificial light does not weaken the radiation, but makes it work less well.
Use and Maintenance
Using for the first time
Make sure that the power socket you intend using is earthed and the correct voltage (220-240V-
50Hz). Start the insect-killer working by plugging the device in. The insect-killer is operating.
The insect-killer can be kept switched on (24 hours a day) all year round.
Replacing lamps
To replace a worn out UV tube you must remove the plug from the socket and remove the
collection tray by pulling it out of the side of the device. Unscrew the 2x2 screws next to the
suspension eyes. Remove the suspension eyes and top cover. Now unscrew the 2x2 screws on
the front and back of the grill and lift the entire electrical block with the lights out of grill.
Unscrew the ring around the right and left of the light fitting. Slide the rubber rings and the
plastic rings away. You can now turn the strip light 90°, remove it from the fitting and replace it.
Install the lights, rings, grill and tray in their original positions before using the device again.
Cleaning
Regularly empty the collection tray by pulling it out of the side of the device, (see diagram 2 on
page 3).
Too much dust will adversely affect the effectiveness of the light and too much dirt will affect the
way insects are destroyed. So clean the
device regularly. To do that, pull the plug out of the power socket and remove the collect tray.
When you now place the device on a work surface, you can remove dust and dirt, for example
with a vacuum cleaner, duster or soft brush. Do not use any moisture or corrosive cleaning
agents in the insect-killer.
You can dust off the outer side of the device using a soft cloth.
Safety notices
 Close supervision is necessary when the product is used near children or incapacitated
persons. The device is not suitable for use by persons (including children) with a physical,
sensual or mental limitation or a lack of experience and knowledge, irrespective of whether
they are being supervised or have been issued with instructions in relation to the use of the
device by a person who is responsible for their safety. Always ensure that children cannot
play with the device. The screen that kills the insects is electrified!
 Only connect the Fly Away 30-2/40-2 IPX4 to an earthed socket with a 220-240V-50Hz
power supply.
 Make sure you NEVER touch the electrified screen when the device is in use: not with your
fingers, or with a pen, piece of paper or other object of any kind. If you do, you will receive a
strong electric shock and you may also cause a fire! NEVER push objects into the insect-
killer through the safety screen.
 In order to avoid health risks, do not expose persons to the UV radiation of the insect killer for
more than 8 hours per day.
9