Peg-Perego Book Notice D'emploi page 21

For swivelling wheels, lower the lever (arrow 1). For
fixed wheels, move the lever in the opposite direction
(arrow 2). We recommend using fixed wheels on rough,
uneven surfaces (fig_a).
BRAKE: to set the brakes on the stroller, lower the
levers on the rear wheels with your foot (Fig.b). To
release the brakes, lift the lever.
Always set the brakes when the stroller is not moving.
10• ADJUSTING THE HANDLES: the handles can be set into
4 different positions. For the highest position, push the
side buttons and lift the handle upwards at the same
time. Release the buttons. To lower the handles, do the
opposite .
11• HOOD: to assemble the hood, fasten the hood's side
attachments onto the sockets until they click (Fig.a);
expand the hood frame so that the fabric is fully
stretched (Fig.b).
12• Button the hood onto the stroller's backrest (Fig.c), on
both sides and inside the handle (Fig.d).
To remove the hood: unfasten the hood's side
attachments from the chassis by pressing the external
button (as shown in Fig.e) and unbutton it from the
backrest, the sides of the stroller and inside the handle.
13• The hood has a fabric loop, for tying toys (Fig.a).
The hood may come with different features
depending on the collection chosen.
The hood may come with a clear viewing panel
offering UV protection, through which it is possible to
see the child (Fig.b).
14• The hood can be adjusted to two positions (Fig. a).
Undo the zip (Fig. b) and stretch the fabric flap to see
the child and to let more air under the hood (Fig. c).
15• FOOT MUFF - Book Completo
To fasten the foot muff to the stroller:
- button it to the bottom of the footrest (Fig.a)
- fit it over the front bar and button it on (Fig.b).
- fasten the two buttons on the inner side of the foot
muff as shown in the figure (Fig.c).
The foot muff is now properly fastened.
- The foot muff also comes with a hand muffler for the
child (Fig.d).
16• The foot muff can also be applied another way:
- fasten the two closest buttons on the inner side of the
foot muff (Fig. a)
- place the foot muff over the seat, excluding the front
bar (Fig.b);
- fasten it to the sides, as shown in the figure (Fig. c).
The foot muff is now properly fastened.
17• FOOT MUFF- EMBOSSED FABRIC COLLECTION:
- fit the foot muff over the front bar (Fig.a);
- fasten the two lateral Velcro strips on both sides (Fig.b);
- detach the Velcro on the foot muff (Fig.c);
- fit it over the footrest (Fig.d);
- fasten the two lateral elastics on both sides (Fig.e)
- fasten the buttons under the footrest (Fig.f).
18• RAINCOVER for complete Book:
to fit the rain canopy, extend it over the stroller and
snap fit the buttons on both sides of the hood (Fig.a).
Fasten the elastic loops including the chassis in the
lower part of the stroller (Fig.b).
• Do not use the rain canopy indoors and always make
sure that the child is not too hot.
• Do not place the rain canopy near heat sources and
pay attention to cigarettes.
• Make sure that the rain canopy does not interfere with
any moving mechanism of the stroller.
• Always remove the rain canopy before folding up the
stroller.
• Wash with a sponge and soapy water. Do not use
detergents.
19• 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
20• To tighten the waist strap, pull on both sides in the
direction of the arrow. To loosen it do the opposite.
21• To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
WARNING: To fasten the belts in the third eyelet, lift the
fabric, as they are hidden in the lining.
22• ADJUSTING THE FOOTREST: the footrest can be adjusted
to 2 positions. To lower the footrest, push the two little
side levers downwards and lower the footrest at the same
time. To raise the footrest, push it upwards until it clicks.
23• ADJUSTING THE BACKREST: the backrest can be reclined
into 4 positions. To lower the backrest, lift the handle
and lower the backrest at the same time. Block it in the
desired position. To raise the backrest, lift the handle
and raise the backrest at the same time. Block it in the
desired position.
24• FRONT BUMPER BAR: to attach the front bumper bar
remove the protection caps (Fig.a) and store them.
After removing the caps, insert the ends of the bumper
into the armrests until they click (Fig.b).
25• The bumper bar can be opened on one side so an older
child can climb on and off more easily. To open the
bumper bar, push the button on the side and pull the
bar outwards (Fig.a)
To remove the bumper bar, press the two buttons on
the sides and pull the bar outwards (Fig.b).
When the bumper bar is off, replace the protection
caps onto the chassis armrests to close them.
26• COLLAPSING THE STROLLER: to collapse the stroller,
put the front wheels into fixed position, close the hood
(if on the stroller) and remove the car seat (if on the
chassis).
- Align the handle with the stroller chassis as shown in
the picture (fig_a);
- lift the fastening hooks on the two sides of the chassis
(fig_b);
- Pull the interior handle placed behind the seat (fig_c)
and lift at the same time (fig_d).
27• then let the handle drop forwards until the stroller is
completely closed (fig_e).
Check that it has fastened to the closing hook on both
sides. If it has not, fasten the closing hook properly as
shown (fig_f).
The collapsed stroller is free standing.
To open the stroller, press on the frame and unfasten
the locking attachments on both sides (fig_g).
28• For greater compactness, it is possible to remove the
- 21 -