Replacing The Pen Tip - Wacom DTF-720 Guide D'installation Et Manuel D'utilisation

REPLACING THE PEN TIP

The pen tip (nib) will wear with normal use. Excessive pressure will cause the nib to wear sooner.
A worn nib may damage the coating on the DTF-720 display screen. To avoid this, periodic tip
replacement is recommended.
When the nib gets too short or develops a sharp edge, you can replace it with one of the extra nibs that
came with the pen.
To remove the old nib:
Clasp it with a Wacom nib removal tool, pair of
tweezers, needle-nosed plier, or similar
instrument and pull the old nib straight out of
the pen.
W
ARNING
Prevent children from swallowing the pen tip or side switch. The pen tip (nib)
or side switch may accidentally be pulled out if children are biting on them.
Important: When the pen is not in use, place it in the pen storage compartment or lay it flat on
your desk. To maintain the sensitivity of your pen, do not store the tool in a container where it
will rest on its tip.
To insert a new nib:
Slide it straight into the barrel of the pen.
Firmly push the nib until it stops. The new nib
will slide into the correct position.
Appendix
Page 45