Replacing The Pen Tip - Wacom DTF-521 Guide D'installation Et Manuel D'utilisation

REPLACING THE PEN TIP

The pen tip (nib) will wear with normal use. Excessive pressure will cause the nib to wear sooner.
A worn nib may damage the coating on the DTF-521 display screen. To avoid this, periodic tip
replacement is recommended.
When the nib gets too short or develops a sharp edge, you can replace it with one of the extra nibs that
came with the pen.
To remove the old nib:
Clasp it with a Wacom nib removal tool, pair of
tweezers, needle-nosed plier, or similar
instrument and pull the old nib straight out of
the pen.
W
ARNING Prevent children from swallowing the pen tip or side switch. The pen tip (nib)
or side switch may accidentally be pulled out if children are biting on them.
Important: When the pen is not in use, place it in the pen tray, the pen storage compartment,
or lay it flat on your desk. To maintain the sensitivity of your pen, do not store the tool in a
container where it will rest on its tip.
Appendix
Page 44
To insert a new nib:
Slide it straight into the barrel of the pen.
Firmly push the nib until it stops. The new nib
will slide into the correct position.