Qlima Ronda 80 Manuel D'utilisation page 166

Stove goes
out, alarm
"AlAr no FirE"
is displayed
15 minutes
after start-
ing, the stove
displays the
"ALARM NO
ACC" alert
4
166
The pellet hopper is
empty
The brazier is dirty
The auger motor is de-
fective
Electronic printed circuit
board is defective
The temperature sensor
has not detected the
minimum temperature
threshold to initiate
start-up
Not enough combustion
air is reaching the fire
Wooden pellets are not
of a good quality
Auger is blocked
The ignition mechanism
is defective.
The temperature sensor
has not detected the
minimum temperature
threshold to initiate
start-up
Outdoor temperature is
too low.
Wooden pellets are damp
Temperature sensor is
defective
Electronic printed circuit
board is defective
The hopper is empty
Fill the pellet hopper with pellets
Clean the brazier
Replace the auger motor Only to be done
by a Qlima-approved technician
Replace the printed circuit board Only to
be done by a Qlima-approved technician
Empty the combustion chamber and start
again if the problem recurs. Contact a
Qlima-approved technician if the problem
persists.
Check the following (can be done by
end-user):
- Possible obstruction of the combustion
air inlet pipe at the rear of the stove.
Clean the fresh air inlet pipe.
- Combustion chamber grate slots blocked
and/or too much ash or dirt in combustion
chamber and requires cleaning. Only to be
done by a Qlima-approved technician.
- Heat exchanger in the stove is dirty.
Clean the heat exchanger.
Try better quality pellets
Unplug the stove at the mains socket. Re-
move the protective grill from the hopper
and clean the hopper. Carefully clean the
visible parts of the auger. Refit the pro-
tective grille and start again. Contact a
Qlima-approved technician if the problem
persists.
Replace the ignition mechanism. Only to
be done by a Qlima-approved technician
Empty the combustion chamber and start
again if the problem recurs. Contact a
Qlima-approved technician if the problem
persists.
Empty the combustion chamber and start
again. Contact a Qlima-approved techni-
cian if the problem persists.
Only use fry wooden pellets.
Replace the sensor. Only to be done by a
Qlima-approved technician
Replace the electronic printed circuit
board. Only to be done by a Qlima-ap-
proved technician
Fill the pellet hopper.