EINHELL GC-EL 2600 E Mode D'emploi D'origine page 17

Anleitung_GC_EL_2600_E_SPK1__ 14.10.13 11:06 Seite 17
(blower/vacuum) more difficult to operate as a
result of the material that swirls up off the
ground. When this occurs, simply flip the switch
back and forth a few times, which should bring it
back to the normal feel.
b To clean the interior of the housing undo the
screw connection (Fig. 8a/Item A) and remove
the cover (Fig. 8a/Item B). Never use cleaning
agents or liquids for cleaning purposes. Remove
deposits with a brush, a dry cloth or compressed
air. When you fit the cover, make sure that the nib
at the bottom end of the cover (Fig. 8b/Item A) is
inserted into the corresponding recess in the
housing (Fig. 8b/Item B).
Important: If the cover is not correctly
closed, a microswitch will interrupt the
power supply and the equipment cannot
operate properly. For this reason, always
check that the cover is properly fitted and
secured.
9.2 Maintenance
Should the tool experience problems beyond
n
those mentioned above, let only an authorized
professional or a customer service shop perform
an inspection.
There are no parts inside the equipment which
n
require additional maintenance.
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
11. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
17