T E C H N I C A L D E S C R I P T I O N - Nissei WSK-1011 Mode D'emploi

is displayed.
The cuff is not properly applied. Properly apply the cuff. If Err-2
appears after re-trying to apply the cuff properly, assume
the cuff is damaged. Contact your dealer.
is displayed.
Batteries are weak. Replace all batteries with new ones.
Nothing is displayed.
???
Batteries are depleted. Replace all batteries with new ones.
Batteries are inserted incorrectly. Reinsert the batteries
correctly.
Battery terminals are not clean. Clean the terminals with dry
cloth.
Touching the keys with tip of finger or nail is touching the key.
Touch the key with the plane of your finger.

T E C H N I C A L D E S C R I P T I O N

WSK-1011 complies with the EMC, electromagnetic compatibility, standard, IEC60601-1-2. Refer to the following tables for
specific information regarding compliance to the standard. WSK-1011, as a medical electrical equipment, needs special
precautions regarding EMC and needs to be installed and put into service according to the EMC information provided
below.
• Portable and mobile RF communications equipments can affect the device.
• The use of accessories other than those specified in this manual may result in increased emissions or decreased immunity
of the device.
• WSK-1011 should not be used adjacent to or stacked with other equipment.
Clock is not displayed.
???
The clock is inactivated. NOTE: Clock is inactivated when batteries
are removed. Adjust date and time and activate the clock.
Measurement date and time are displayed with "
???
The clock is not activated. Adjust date and time and activate
the clock.
Measurement was taken before the clock was activated.
Measurement date and time cannot be saved without clock
being activated.
is displayed.
START/STOP KEY was being touched at installation of batteries.
Turn off the monitor once with "START/STOP" KEY.
If you cannot get correct measurement with the methods above, contact your
dealer. Do not disassemble or tamper with the internal mechanism.
Guidance and manufacturer's declaration - electromagnetic emissions -
WSK-1011 is intended for use in the electromagnetic environment specified below. The customer or the user of
WSK-1011 should assure that it is used in such an environment.
Emissions test Compliance
RF emissions CISPR 11 Group 1
-14-
" and "
Electromagnetic environment - guidance
WSK-1011 uses RF energy only for its internal function. Therefore,
its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
".