P R E C A U T I O N S A N D C O N T R A I N D I C At I O N S - Nissei WSK-1011 Mode D'emploi

Exhaust : Automatic exhaust valve
Power Supply : Two 1.5 volt AAA alkaline (LR03) type batteries
Power Consumption : 2W (max.)
Electric Rating : DC3V/2W
Memory : 2 banks, each stores 60 readings
Operating Condition : +10˚C to +40˚C, 30% to 85% RH (noncondensing)
Transportation/Storage Condition
: -20˚C to +60˚C, 10% to 95% RH (noncondensing)
Coverage wrist circumference
: 12.5 to 22.5 cm
Weight : Approx. 110 g (without batteries)
Size : Approx. 70 x 27 x 70 mm (W x D x H) , not including
the cuff
Protection against harmful ingress of water
: IPX0 (IEC 60601-1)
Protection against electric shock
: Internally powered equipment, Type BF applied part
(cuff)
Mode of operation : Continuous operation
P R E C A U T I O N S A N D C O N T R A I N D I C A T I O N S
Do not use this product without consultation with your doctor if you
are under dialysis therapy or on anticoagulants, antiplatelets or
steroids. Use of this instrument under such conditions could cause
internal bleeding.
For specific information on your blood pressure, contact your
Classification : Internally powered equipment
Key to symbols : Type BF applied part
: Refer to instruction manual/booklet.
: The used electrical and electronic products are not
household waste. Follow your national/local recycling
rules to dispose of them properly. In the EU
countries, please refer to waste management
symbol(s) marked on the package or the instrument.
This device complies
sphygmomanometers Part 1: General requirements, EN1060-3:1997+A2:2009
Non-invasive shygmomanometers Part 3: Supplementary requirements for
electro-mechanical blood
(IEC60601-1-2:2007).
*Accuracy is guaranteed with the measured values that are within the
measuring range.
Specifications are subject to change without notice due to improvements in
performance.
physician. Never make any judgment on your own regarding
measurement results.
Do not use this product along with implantable and wearable medical
electrical equipment such
electrocardiographic monitor. This product is not also intended to be
-5-
with EN1060-1:1995+A2:2009
pressure measuring system
as pacemaker, defibrillator,
Non-invasive
and EMC
or