E W I N G T H E S Av E D R E A D I N G S ( M E M O R Y F U N C T I O N ) - Nissei WSK-1011 Mode D'emploi

V I E W I N G T H E S A V E D R E A D I N G S ( M E M O R Y F U N C T I O N )
Turn off the monitor once with "START/STOP" KEY when the results are
displayed after a measurement.
Refer to page 4 for memory function.
TOUCH MEMORY KEY.
1
Touch MEMORY KEY [1] to review readings saved in the memory
bank [1] and MEMORY KEY [2] to review those in the bank [2].
The average of the saved
readings are displayed.
Note: Average will not be displayed
unless there are two or more
readings saved.
2 TOUCH THE SAME MEMORY KEY AGAIN.
The latest reading saved in the selected bank
is displayed.
The display at the top shows memory
number, measurement date and time
alternately. The latest reading is displayed as
memory "No. 1".
The results are recalled from the latest to the oldest with operation of
MEMORY KEY.
: Average
NUMBER OF
SAVED RESULTS
The bigger memory number indicates the older number.
SWITCHING MEMORY BANKS
Touching MEMORY KEY [2] at display of reading in the bank [1] will switch
the display to reading in bank [2] and touching MEMORY KEY [1] again
will return to the display of result in the bank [1].
3 TURN OFF THE MONITOR.
Touch "START/STOP" KEY.
Even if you do not turn off the monitor, it displays the result for approximately
30 seconds and will turn off automatically.
DELETING SAVED READINGS
1 DISPLAY THE READING TO DELETE.
Display the average reading to delete entire readings in the memory.
TOUCH MEMORY KEY AND KEEP YOUR FINGER TOUCHED TO
2
THE KEY.
Touch MEMORY KEY [1] to delete reading in the memory bank [1] or
MEMORY KEY [2] to delete reading in the bank [2].
The display will start flashing. Keep your finger on the key until the reading is
replaced with " ".
-12-