OWIM HG04641A Instructions D'utilisation Et Consignes De Sécurité page 20

CAUTION! DANGER TO LIFE, RISK OF INJURY AND
MATERIAL DAMAGE! Read the operating and safety instructions
for your drill carefully.
not hit electricity, gas or water lines when you drill into the wall. If
necessary, check with a pipe and cable detector before drilling.
Note: Before mounting the temperature station, please remove
the stand by simply pulling it off.
26
Mark the position of the hole (ø approx. 8 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the screw
the dowel.
Hang the temperature station or outdoor sensor by placing
the hanging slot
20 GB/IE/NI
DANGER TO LIFE! Take care that you do
, into the drilled hole.
28 33
, to the according screw.
22 30
, into
27 32