Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation
Please refer to the following installation examples to set up your system.
POINT TO POINT CONFIGURATION
Source
HDMI Cable
USB Cable
Cat.5e/6 Cable
In this configuration please follow these steps:
1. Connect your HDMI source to the HDMI Transmitter using a High Speed HDMI cable (not included).
2. Connect one end of the Cat.5e/6 cable (maximum length 150m or 492.12ft – not included) to the
RJ45 (UTP) port on the Transmitter, and the other end of the cable to the RJ45 (UTP) port of the
Receiver. Lindy recommends using solid core installation Cat.5e UTP cable or higher.
3. Connect your HDMI display device to the HDMI OUT port on the Receiver using a High Speed
HDMI cable.
4. Connect a free USB port on the source device to the USB-PC port on the Transmitter using the
included USB Type A cable.
5. Connect a USB keyboard and mouse to the USB 1 and USB 2 ports on the Receiver.
6. To use the IR remote control functionality, connect the included IR Transmitter cable to the 3.5mm
IR port on the Transmitter and the IR Receiver cable to the IR port on the Receiver.
7. Place the IR Transmitter in front of the IR port of the equipment you want to control, ensuring the
Eye is in a clear line of sight.
8. Power on both the HDMI source and display.
9. Plug the included DC power supply into the Transmitter and Receiver. The power LED will
illuminate on both units to show they are receiving power.
10. The devices will start to communicate and set up the link. When the link is set up the Status LED
will illuminate and flash slowly on both units.
11. You can now start using the remote console.
Please Note: In order to copy the EDID check that the Transmitter and Receiver are connected and
powered on correctly. When the display shows 'Wait Link Up' press and hold the EDID button on the
Receiver for at least 3 seconds and release when the display becomes blank. The EDID has now been
successfully updated.
Up to 150m (492.12ft)
Transmitter
(No.38264)
Receiver
(No.38265)
Control Console
English
Publicité
