Kenwood Rapid Bake BM450 Mode D'emploi page 9

using your Bread Maker
(refer to illustration panel)
1 Remove the bread pan by holding the handle and
turning the pan to the back of the baking chamber.
2 Fit the kneader.
3 Pour the water into the bread pan.
4 Add the rest of the ingredients to the pan in the order
listed in the recipes.
Ensure that all the ingredients are weighed accurately
7 as incorrect measures will produce poor results.
8 Insert the bread pan into the oven chamber by
positioning the bread pan at an angle towards the
back of the unit. Then lock the pan by turning it
towards the front.
9 Lower the handle and close the lid.
10 Plug in and switch on - the unit will beep and default
to setting 1 (3:15).
11 Press the MENU button
is selected. The breadmaker will default to 1Kg &
medium crust colour. Note: If using the "RAPID
BAKE" , just press the button and the program will
start automatically.
12 Select the loaf size by pressing the LOAF SIZE
button until the indicator moves to the required
loaf size.
13 Select the crust colour by pressing the CRUST button
until the indicator moves to the required crust
colour (light, medium or dark).
14 Press the START/STOP button
the program press the START/STOP button
2 -3 seconds.
15 At the end of the baking cycle unplug the breadmaker.
16 Remove the bread pan by holding the handle and
turning the pan to the back of the baking chamber.
Always use oven gloves as the pan handle
will be hot and take care not to touch the
automatic dispenser on the underside of
the lid as this will also be hot.
17 Then turn out onto a wire rack to cool.
18 Leave the bread to cool for at least 30 minutes before
slicing, to allow the steam to escape. The bread will
be difficult to slice if hot.
19 Clean the bread pan and kneader immediately after
use (see care and cleaning).
until the required program
. To stop or cancel
for
viewing light
The LIGHT button can be pressed at any time to view
●
the program status in the display window or to check
the progress of the dough inside the baking chamber.
The baking chamber viewing light will automatically
●
switch off after 60 seconds..
If the light bulb stops working it must be replaced by
●
KENWOOD or an authorised KENWOOD repairer (see
service and customer care).
automatic dispenser
Your BM450 breadmaker is fitted with an automatic
dispenser for releasing additional ingredients directly
into the dough during the kneading cycle. This ensures
that the ingredients are not overprocessed or crushed
and are evenly distributed.
to fit and use the automatic dispenser
1 Fit the dispenser
arrows .
The dispenser will not locate and lock into position
●
unless fitted the correct way round.
The breadmaker can be used without the dispenser
●
fitted if required but the manual alert will still sound.
2 Fill the dispenser with the required ingredients.
3 The Automatic dispenser operates after approx. 15-20
minutes of kneading and an audible alert sounds as
well in case you need to add ingredients manually.
hints & tips
Not all ingredients are suitable for use with the
automatic dispenser and for best results follow the
guidelines below: -
Do not overfill the dispenser – follow the recommended
●
quantities specified in the recipes supplied.
Keep the dispenser clean and dry to prevent
●
ingredients sticking.
Cut ingredients roughly or lightly dust with flour to
●
reduce stickiness, which may prevent the ingredients
from being released.
4
to the lid using the alignment