Stihl FSA 90 Notice D'emploi page 54

English
Machine supplied with mounting
hardware
Mowing heads and metal cutting
attachments may be mounted.
3
4
5
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Blocking the Shaft
2
7
6
The output shaft (2) must be blocked
with the stop pin (6) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
52
Push the stop pin (6) into the
N
hole (7) in the motor housing.
Rotate the shaft, nut or cutting
N
attachment to line up the hole in the
fanwheel (1) with the stop pin (6).
Push the stop pin (6) home until its
N
end is level with the blades on the
fanwheel (1).
The shaft is now blocked.
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
6
2
Screw the mowing head
N
counterclockwise on to the shaft (2)
as far as stop.
Blocking the shaft
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Remove the mowing head.
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
Mounting the Metal Cutting Attachment
Keep the leaflet and packaging of the
metal cutting attachment in a safe place.
FSA 90, FSA 90 R