Stihl FSA 90 Notice D'emploi page 50

English
8
Place the secured assembly on the
N
handle support (8) with the wing
screw at the side nearest the battery
compartment.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Line up the handlebar at a right
N
angle to the drive tube – check
distance A again.
Tighten down the wing screw firmly.
N
48
Mounting the control handle
12
11
9
10
Take out the screw (9) – the nut (10)
N
remains in the control handle (11).
Push the control handle onto the
N
handlebar (7) until the holes (13)
line up – the trigger (12) must point
towards the cutting attachment.
Insert the screw (9) and tighten it
N
down firmly.
13
7
13
Push the corrugated tube (14) into
N
the retainer (15).
14
15
14
15
FSA 90, FSA 90 R