Publicité
Les langues disponibles
Les langues disponibles
Data Transfer (for Model FMT-110WT only)
Model FMT-100WT instruments can transfer measuring data by means of a RS-232C interface. A 9-p D-Sub
connector is provided for this purpose, which can be found at the side of the instrument. A connector cable for
the serial I/O port is also included in the scope of delivery.
RS-232C Interface
The RS-232C interface can be used for the direct communication between an appropriate serial I/O-card of a
computer and the instrument. The minimum requirement for the data transfer up to 19200 baud is the
connection of the RXD, TXD and GND communication terminal.
Specification
Baud rate
Data length
Stop bit
Parity
Protocol Code
Extern >> FMT
AAcr
ABcr
ACcr
ADcr
AEcr
AFcr
AGcr
AHcr
BAcr
BBcr
BB1cr
BB2cr
BB3cr
BDcr
BEcr
BFcr
cr
FMT >> Extern
Average data output
3. digit:
4.-6. digit. Value incl. floating decimal point
2400, 4800; 9600 or 19200 (selectable, see general settings)
8 bits
1
None
+ /or -
Tare
Stop Output
Change to Peak Mode
Change to Average Mode
Reset Peak
Change Units to kg (g)
Change Units to N
Change Units to lb (oz)
Data output request (single reading)
Data output request (10/sec)
Data output request (20/sec)
Data output request (50/sec)
Data output request (100/sec)
Units confirmation request
Peak data output request
Minus peak data output request
(carriage return)
NA
19
cr
Publicité
