NEC NP01SW Série Mode D'emploi page 5

IMPORTANT INFORMATION
SETUP Button on this product
• After completion of connection between this product and the projector or display, make sure
to press the SETUP button on this product once at the beginning.
For more details on the SETUP button, please refer page ENG-9.
Please be reminded to perform the following steps 1 to 4 before pressing the SETUP but-
ton.
(1) Power on each device connected with this product.
(2) Select input terminal on the projector or display for this product.
(3) Press a terminal button among the input terminal HDMI 1, 2 and 3 from which the image
you want to display will be transmitted. Image will be displayed on the projector or dis-
play. It does not matter if it's in no signal state.
(4) Press the SETUP button on this product.
While the SETUP operation is processing, all indicators are turned up. When the SETUP
operation is completed properly, the indicators are turned off and go back into the previ-
ous state If the SETUP operation is failed to complete, all indicators flushed in 2 cycles
and go back into the previous sate
• By pressing the SETUP button for the first use, every time pressing one button among
HDMI1, 2 and 3 accompanied to switch the image input terminal on the connected projec-
tor or display from the next time.
• If the SETUP button is not pressed, the operation buttons may not work properly.
• The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are
trademarks or registered trademarks of HDMI Licensing LLC in the United States and other
countries.
• HDBaseT is a trademark of HDBaseT Alliance.
TM
• MHL, Mobile High-Definition Link and the MHL Logo are trademarks or registered trademarks
of the MHL, LLC.
• Other product names and company logos mentioned in this manual may be the trademarks
or registered trademarks of their respective holders.
Cautions
(1) Unauthorized reprinting of the contents of this manual is prohibited.
(2) The contents of this manual are subject to change in the future without notice.
(3) The contents of this manual have been prepared with scrupulous care, but please notify
NEC should you have any doubts or notice any mistakes or omissions.
(4) Please note that NEC will accept no responsibility whatsoever for claims for damages, lost
earnings, etc., arising from the use of this product, regardless of article (3) above.
(5) NEC will replace any manuals presenting incorrect collation or missing pages.
ENG-3