Receiver Box (Included With The Np01Sw2) - NEC NP01SW Série Mode D'emploi

2-2. Receiver box (included with the NP01SW2)

[Left side]


HDBaseT port (input)
①
Connect this to the interface selector's HD-
BaseT port (output) by a commercially avail-
able LAN cable.
HDMI output terminal
②
Connect this to the HDMI input terminal
on the projector or display by the included
HDMI cable.
USB-B port
③
Connect this to the projector's USB-A port
by a commercially available USB cable pri-
mary for utilizing the projector's VIEWER
function.
USB-A port
④
Connect this to the projector's USB-B port
by a commercially available USB cable pri-
mary for utilizing the projector's Interactive
White Board Kit or USB Display function.
Selector switch (
⑥
USB-A
USB-B

) Interface selector
USB-A: Inactive
USB-B: Active
USB-A: Active
USB-B: Inactive
[Right side]

 
PC CONTROL terminal
⑤
Connect this to the projector's PC CON-
TROL terminal or the display's RS-232C
terminal by the included RS-232C cable.
USB-A/USB-B selector switch
⑥
Use this to select either the USB-A or USB-
B port on the receiver box. Only one port
(USB-A or USB-B) is available on the re-
ceiver box.
Make sure to perform switching operation
when this product is in powered OFF state.
Use a long stick for switching from/to USB-
A/USB-B.
ENG-12
Receiver box
USB-A: Active
USB-B: Inactive
USB-A: Inactive
USB-B: Active