Mounting The Interface Selector On A Wall - NEC NP01SW Série Mode D'emploi

3.Mounting the interface selector on a wall

Mount the mount unit to 2 places on the main unit's rear surface and on the wall where the main
unit is to be fixed. Also, use the mount unit to mount the AC adapter onto the wall.
[About the screws]
• Use the 5 screws included with the interface selector (M3). With the NP01SW2, 1 more screw
(M3) is included for use with the receiver box.
• In addition to the above screws, prepare 8 pcs of commercially available
the interface selector onto the wall.
NOTE
• Prepare 4 screws that have enough durability to support the 1.4kg (3.1bls) interface se-
∅
lector.
• Use a magnetized screwdriver with a thin neck for installing the interface selector on the wall.
3-1. Mounting the interface selector on a wall
(1) Fasten the main unit mount units (large and small) to the main unit's rear surface.
Fasten using 3 of the included screws (M3).
(2) Fasten the wall mount unit to the wall on which the interface selector is to be fixed.
Fasten by 4 pcs of commercially available
T h
e w
a l l
s i d
e
ENG-13
4 screws.
∅
4 screws to mount
∅