NEC NP01SW Série Mode D'emploi page 21

Utilizing the VIEWER function on the projector by this product with the
USB memory
• Not support connection with displays.
Some models are not equipped with the VIEWER function. Check your projector's user's
manual or the NEC web site to see if your projector is equipped with the VIEWER function.
• Connect the receiver box included with the NP01SW2.
IMPORTANT
• For utilizing the VIEWER function, switch the receiver box's USB-A/USB-B selector switch
to USB-B before connecting the cable.
Receiver box
HDBaseT port
LAN cable (commercially available)
Connect to a power outlet
NOTE
• Use the projector's remote control to switch to the VIEWER function. The interface selector's
remote sensor is not available when a receiver box is connected, so operate the remote con-
trol pointing it towards the remote sensor on the projector.
RS-232C cable (included)
PC CONTROL terminal
USB cable (commercially available)
USB-A port
ENG-19
USB-A port
USB memory device