NEC NP01SW Série Mode D'emploi page 20

Connecting to a computer not equipped the HDMI output terminal
• Use the projector's USB Display function. Not support connection with displays.
Some models are not equipped with the USB Display function. Check your projector's
user's manual or the NEC website to see if your projector is equipped with the USB Display
function.
• Connect the receiver box included with the NP01SW2.
IMPORTANT
• For utilizing the USB Display function, switch the receiver box's USB-A/USB-B selector
switch to USB-A before connecting the cable.
HDBaseT port
LAN cable (commercially available)
Connect to a power outlet
NOTE
• Switching to the USB Display function can be performed by the Image Express Utility Lite
booted on a computer.
Switching to the USB Display function using the projector's remote control, operate the re-
mote control pointing it towards the remote sensor on the projector. When a receiver box is
connected, the interface selector's remote sensor is not available.
• When computers are connected to both the interface selector's HDMI input terminal and
USB-B port, the screen of the computer connected to the USB-B port is displayed directly
after the interface selector's power is turned on.
RS-232C cable (included)
Receiver box
USB cable (commercially
available)
PC CONTROL terminal
USB cable (commercially available)
ENG-18
USB-B port
USB-B port