NEC NP01SW Série Mode D'emploi page 12

For your reference
• The status of the HDMI1, 2, and 3 buttons, MIC, MIC SELECT, and MIC VOL. +/- buttons are
stored in the memory even when the interface selector's power is turned off.
• Follow the below steps for resetting this product to the factory default settings.
(1) Turn off the main power switch.
(2) While pressing the POWER OFF button, turn on the main power switch.
(3) Release the POWER OFF button when all indicators are lighted on.
• The reset completion is informed by all indicators blink.
(4) When the reset is completed, turn off the main power switch.
(5) Turn on the main power switch again.
NOTE
• For 5 seconds after pressing any buttons on this product, do not turn off the main power
switch. If the main power switch is turned off within 5 seconds after pressing any buttons, the
saved values may be initialized.
ENG-10