Using Built-In Touch Panel Display - NEC NP01SW Série Mode D'emploi

5-3. Using built-in Touch Panel display

Connect the receiver box included with NP01SW2 same as 5-2 Using separately sold Interac-
tive White Board Kit for the projector described on the previous page.
IMPORTANT
• For utilizing the built-in Touch Panel display, switch the receiver box's USB-A/USB-B selec-
tor switch to "USB-A" before connecting the cable.
For connection between the built-in Touch Panel display and the receiver box, make sure to use
the cables listed below same as 5-2 Using separately sold Interactive White Board Kit for the
projector described on the previous page.
• HDMI cable (Included)
• RS-232C cable (Included)
• USB cable (Included with the built-in Touch panel display)
ENG-22