Connecting The Monitor And Turning The Monitor On And Off; Connecting The Monitor To A Computer - Sharp LL-191A Mode D'emploi

Connecting the monitor and turning the monitor on and off

CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.

Connecting the monitor to a computer

Connect the accessory analog signal cable to the
analog RGB output terminal of the computer.
Analog RGB terminal
(Mini D-sub 15 pin, 3 row)
Analog signal cable
- Paying attention to connector direction, firmly
insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.
If connecting to a D-sub15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.
Macintosh conversion adapter
Note:
- If connecting to the Sun Ultra series, a
conversion adapter (commercially available)
may be required.
Analog RGB terminal
(Mini D-sub 15 pin, 3 row)
Connect the accessory audio cable
When the accessory audio cable is connected to
the audio output terminal of the computer, the
sound of the connected computer is output from
the monitor speakers. You can also use the
headphone jack of the display.
13
Audio input terminal
Audio output terminal
Audio cable