Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – MWL
INSTALLATION
Remove Lens Assembly
1.
Press spring clips to unlatch the lens assembly
(Figure 1).
2.
Pull lens assembly away from light fixture.
3.
To install, reverse steps 1 and 2.
Figure 1. Lens Assembly Removal
Remove Reflector Assembly
1.
Remove (2) screws (Figure 2).
2.
Pull reflector assembly away from fixture and allow
reflector assembly to hang.
Figure 2. Reflector Assembly Removal
2
COOPER LIGHTING SOLUTIONS
Spring Clip
IB519122EN
Installation instructions
Wall Mount
1.
Remove channel cover by turning channel fastener¼ turn
(Figure 3).
Plastic Washers
Figure 3. Mount To Wall
2.
Select the correct type fasteners to use for the mounting
surface (not supplied). Must fit through the ¼" inside
diameter of plastic washer.
3.
Thread mounting fastener through the keyhole from
inside the fixture.
4.
Mounting fastener is then threaded through the plastic
washer. The plastic washer is located between the
channel and the wall.
Standard Assembly
1.
Overall assembly (Figure 4).
2.
Feed power wires through knock out located on back of
channel.
Figure 4. Overall Assembly
Install Lens Assembly
1.
Fit lens assembly
over the channel
with narrow lens in
the up position.
2.
Install #6 x 3/4"
flat head screw as
shown.
3.
Install 1" length of
tape in groove to
cover screw head.
4.
Typical @ each
end.
Figure 5. Lens Lock Direction
Bolt
(Supplied By Others)
Narrow lens in
up position
Publicité
