Vector™ Quick Start Manual - Garmin Vector Manuel De Demarrage Rapide

Vector™ Quick Start Manual
Read all instructions carefully before installing and using the
Vector™ system. Improper use could result in serious injury.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Go to www.garmin.com/vectorowner
including bike compatibility, software updates, and video
tutorials.
Tools Needed
• 15 mm pedal wrench
• Bike grease
• 3 mm hex key
• 4 mm hex key
Installing Vector Components
Preparing the Crank Arms
1
Confirm the compatibility of your bike at
/vectorowner.
2 Remove the existing pedals.
3 Clean the threads, and remove old grease.
Determining Pedal Pod Clearance
The pedal pod should contact the crank arm only at its mounting
face, because this is the load-bearing connection. If the pedal
pod contacts the crank arm anywhere else, the pedal pod may
fracture when the pedal is tightened.
• If the mounting face surrounding the threaded hole in the
crank arm is recessed, use one or two washers
recess.
NOTE: Do not use more than two washers.
• Make sure the pedal pod mounting face
arm only at its mounting face (or the washer used to fill the
recess).
If it touches anywhere else, you can use another washer to
provide the necessary clearance.
• If it is close, you can confirm proper clearance by sliding a
piece of paper between the metal bracket and the crank arm
face.
• If the mounting face of the crank arm is protruding, do not
use washers.
2
WARNING
NOTICE
for the latest information
www.garmin.com
NOTICE
to fill the
contacts the crank
Installing the Pedal Pod and Pedal
NOTE: The left and right pedal pods are the same.
1 Install the left pedal first.
2
Apply a thin layer of grease on the pedal spindle
pedal pod where it contacts the pedal spindle.
3
On the pedal spindle, stack the pedal pod and any required
washers .
TIP: You must carefully bend the cable
4
Insert the spindle into the crank arm
5
Hand tighten the spindle.
NOTE: The left pedal spindle has a left-handed (reverse)
thread.
TIP: Power and cadence calculations are not impacted by
the orientation of the pedal pod. Garmin
placement of the pedal pod on the leading edge of the crank.
When the crank is in the forward position, the pedal pod
should be pointing downward.
6 Rotate the crank arm to check for clearance.
The pedal pod should not interfere with any part of the bike.
7 Use the pedal wrench to tighten the spindle.
NOTE: Garmin recommends torque of 25 to 30 lbf-ft. (34 to
40 N-m).
8
Firmly plug the cable into the spindle.
9
Rotate the crank arm to check for clearance.
10 Repeat steps 2–9 to install the right pedal.
NOTE: If the pedal pod cable rubs the chain, you can add
one or two washers between the pedal pod and the crank
arm to increase clearance.
Installing the Shoe Cleats
NOTE: The left and right cleats are the same.
1
Apply a thin layer of grease on the cleat bolt threads.
2
Align the cleat , washers
3 Use a 4 mm hex key to loosely attach each bolt to the sole of
the shoe.
4
Adjust the cleat to the shoe in your preferred position.
This can be adjusted after a trial ride.
5
Tighten the cleat firmly to the shoe.
NOTE: Garmin recommends torque of 4 to 6 lbf-ft. (5 to 8 N-
m).
and the
out of the way.
.
recommends
®
, and bolts .