Publicité
Les langues disponibles
Les langues disponibles
Conformiteitsverklaring
Hiermee verklaart de firma Indexa GmbH, dat de draadloze gong FD20 voldoet aan de
principiële eisen en aan de andere relevante voorschriften van de richtlijn 1999/5/EG. De
conformiteit werd aangetoond. De volledige conformiteitsverklaring is na te lezen op:
www.pentatech.de.
Recycling
Werp verpakkingsmateriaal en lege batterijen of defecte apparaten niet zomaar weg,
maar laat deze recyclen. Vraag uw gemeente naar het adres van het recyclingbedrijf in
uw buurt.
Introduction
Read through these operating instructions fully and carefully. The operating instructions belong
to this product and contain important points concerning bringing the appliance into service and
its operation. Always pay attention to all safety instructions. Should you have any questions or be
unsure about operating the appliance - ask a specialist, inform yourself on the internet under
www.pentatech.de. Keep these instructions in a safe place and should the need arise pass them
on to a third party.
Proper use
This wireless chime consists of a weatherproof doorbell with transmitter FD2K and a chime with
receiver FD2G. The transmitter has a unique coding which has already been enrolled to the
receiver. The set can be extended by other transmitters (doorbell FD2K or motion detector FD2B)
as well as chimes FD2G. When pressed, the doorbell sends a wireless signal to the chime which
responds with a selectable chime sound and/or an optical strobe signal. The wireless doorbell
can be used as doorbell as well as a mobile pager, e.g. for elederly people, it can be used at the
counter of a shop or at a reception.
The doorbell is protected against sprayed water (IP44) and thus also suitabel for outdoor use. It
is powered by a 12 V MN21/23A alkaline battery (supplied). The wireless chime is to be
connected to a 230 V AC, 50Hz mains outlet and is for indoor use only.
Any other use or change of the appliance is improper use. No liability shall be assumed for
consequential damage as well as damage which is caused by improper use or incorrect
operation. This appliance is not intended to be used by people (including children) with restricted
physical, sensory or mental capacities, or a lack of experience and/or knowledge, unless they are
supervised by, or receive instructions how to use the appliance from, a person responsible for
their safety. Children must be supervised in order to ensure that they do not play with the
appliance.
Package contents
After unpacking, immediately check that the contents are complete and that the equipment is
undamaged.
1 Doorbell
2 Screws
1 Wireless chime
2 Wall plugs
Features and Equipment (see illustrations)
1 Wireless chime
6 Doorbell
2 LEDs
7 Nameplate
3 Chime selection button
8 Gap
4 Volume button
9 Screws
5 LED
10 Hook
Technical data
Transmitter FD2K:
Operating voltage:
12 V
DC
Current draw:
max. 30 mA
Power supply:
1 x 12 V MN21/21A alkaline battery (supplied)
Transmission frequency: 433.92 MHz
Transmitter range:
up to 200 m (outdoors)
Coding:
factory preset (>1,000,000 possible codes)
Protection class:
IP44
Operating temperature:
0 °C to +40 °C
Case dimensions:
approx. 34 x 88 x 20 mm
Weight:
approx. 39 g (incl. batteriy)
Wireless chime FD2G:
Operating voltage:
230 V
AC, 50 Hz
Power consumption:
max. 0.1 W (standby)
max. 0.5 W (operation)
Radio reception:
433.92 MHz
Chime sounds:
24 chimes selectable
Chime sound level:
max. 82 dB(A) at 0.3 m (4 levels selectable)
Flashing light:
4 x LED
Operating temperature:
0 °C to +40 °C
Application area:
indoors
Case dimensions:
approx. 80 x 87 x 28 mm (without plug)
Weight:
approx. 86 g
Safety instructions
Danger! Life and health are endangered if the following instructions are not observed.
Do not leave small children unsupervised with the appliance, batteries, packing material or
!
small parts. Otherwise there is a risk of fatal injury due to choking
The mains power supply for the wireless chime must be 230 V AC, 50 Hz and fused
!
according to local regulations.
Do not expose the wireless chime to moisture. Otherwise there is a danger to life or risk of
!
injury.
Do not damage any gas pipes, or electricity or telecommunication cables when fixing.
!
Otherwise there is a danger to life or risk of injury or damage.
Make sure that the batteries are not short-circuited, nor thrown into fire. They must also not
!
be recharged or opened. There is a danger of fatal injury due to explosion.
Leaking or damaged batteries can cause burning upon contact with the skin. Where this is
!
the case use suitable protective gloves.
Attention! Non-observance of the following instructions puts property at risk of damage.
Only operate the appliance with the approved types of batteries.
!
Avoid the wireless chime coming into contact with moisture.
!
If the equipment will not be used for a long time, remove the battery.
!
Operation
Open the housing of the doorbell by levering it carefully with a screwdriver at the gap [8] at
!
the side of the doorbell.
Loosen the two screws [9] that fix the circuit board in the cover of the doorbell, and remove
!
the circuit board.
Insert the supplied battery (pay attention to the markings of the polarity BAT+ and BAT-
!
on the circuit board) and fix the circuit board with the screws.
GB
1 adhesive pad
1 12 V battery
11 Circuit board
12 Battery
13 Plugs
14 Screws
Publicité
