Din Rear-Mount; Switching The Dsp Setting Mode - Pioneer DEH-P88RS Manuel D'installation

DIN Rear-mount

Installation using the screw holes
on the side of the unit
1. Remove the frame.
To remove the frame, extend top and bottom of
the frame outwards in order to unlock it. (When
reattaching the frame, point the side with a groove
downwards and attach it.)
• It becomes easy to remove the frame if the front
panel is released.
2. Fastening the unit to the factory
radio mounting bracket.
Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the screws
at 2 places on each side. Use either truss screws (5
× 8 mm) or flush surface screws (5 × 9 mm),
depending on the shape of the screw holes in the
bracket.
Factory radio mounting bracket

Switching the DSP setting mode

•
Frame
Screw
Dashboard or Console
This product features two operation modes:
the 3-way network mode (NW) and the
standard mode (STD). You can switch
between modes as desired. Initially, the
DSP setting is set to the standard mode
(STD).
After switching, reset the microprocessor. (Refer
to operation manual.)
• Use a thin standard tip screwdriv-
er to switch the DSP switch on the
side of this product.
14