Table des Matières
Publicité
Hitachi Plasma TV Horizontal Wall-mount Unit
Model
PWT001
Thank you for purchasing the Hitachi Plasma TV Wall-mount Unit.
To ensure correct usage, please read this instruction manual thoroughly. After reading, please store this
manual in a safe place for future reference.
This plasma TV wall-mount unit is for use with the following models:
HITACHI Plasma TV CL32-PD2100, CL37-PD2100, CL42-PD2100, 32PD5100, 42PD5100, 42PMA500
32PD5000, 32PD5200, 32PD5300, 37PD5200, 42PD5000, 42PD5200, 42PD5300, CMP4211/2, CMP4213/4
Special techniques are necessary for installation of the plasma TV.
■ Do not attempt to perform this work by yourself.
■ Request an installation specialist to install this unit.
■ This company assumes absolutely no responsibility for injuries and damages that may occur due to
improper installation and handling.
■ Please remember that if you remove the plasma TV set from the wall later, you will find the screw holes and
anchor bolts for the mounting unit left on the wall. Also note that a long use of the plasma TV set may
discolor the wall around it due to its heat and air flow.
To dealers and shops
●
To ensure customer safety, be sure to design the installation location so that the strength is sufficient to
withstand the weight of both the plasma TV and the wall-mount unit.
●
Always use at least two persons for all installations.
●
Fully tighten all of the mounting screws as specified in the installation instructions.
Parts Configuration Chart
Installation Instructions
Wall-mount metal
(top)
1
x
M6
TV-mount metal
x
2
x
Wall-mount metal
(center)
1
x
Wire clamp
x
Wall-mount metal
(bottom)
1
x
In the parts packing
M5 - 6 flat washer
18 screw
x
8
10
x
2
Parts for CL37-PD2100 only
M6
Bracket (R),(L)
4
x
1 each
x
18 screw
x
Publicité
Table des Matières
