Group Separation - Selve i-R Receive Notice D'utilisation

Transmitter programming procedure
GB

3.) Group separation

A group is an arrangement of several receivers which can be
controlled using one send channel. This transmitter is deleted
after the group separation is completed.
During group separation, each motor moves once only, for
3 seconds, in the space of approx. 2 minutes in a time slot
determined according to a random principle. If the motor is
stopped by any transmitter, this is learnt into the receiver.
First press the STOP button and then the UP and DOWN buttons
as well. Keep all three but tons depressed for 9 se conds, in
order to start the group separation (wait until the transmitter
control light flashes three times).
The receiver acknowledges activation of the group separation by
a short movementof the motors of 3 seconds. Within the
3-second time slot, stop the movement of the motor using the
STOP button on the transmitter to be learnt. The transmitter will
be learnt and the receiver will no longer be in group separation
mode.
38