Reprogramming If A Transmitter Is Faulty Or Lost (Only For Qualified Personnel); Reset The Receiver To The Factory Setting (Only For Qualified Personnel) - Selve i-R Receive Notice D'utilisation

Transmitter programming procedure
2.1) Reprogramming if a transmitter is faulty or lost
(only for qualified personnel)
Only use if a programmed transmitter is no longer available
(faulty or lost). In order to program a new transmitter, the re cei-
ver has to be put into reprogramming mode by disconnecting it
from the mains supply. Subsequently press the PROG button of
the new transmitter for 3 sec. All the old transmitters have been
deprogrammed.
Fuse
3 sec. 3 sec.
2.2) Reset the receiver to the factory setting
(only for qualified personnel)
The factory setting means that no transmitter has been pro-
grammed and no intermediate positions have been set. In order
to reset to receiver to the factory setting, the receiver has to be
put into reprogramming mode by disconnecting it from the
mains supply. Subsequently press the PROG button of the
transmitter or i-R Receive for 9 sec.
Fuse
3 sec. 3 sec.
3 sec.
3 sec.
37
Transmitter
➡
Transmitter/
i-R Receive
➡
GB
3 sec.
9 sec.