Transmitter Programming Procedure; Initial Operation; Learn In The First Transmitter - Selve i-R Receive Notice D'utilisation

Transmitter programming procedure

Einlernen des Funks
The operating instructions provided with transmitters must be com-
plied with at all times.
Safety instructions
• Risk of injury through an electric shock.
• The programming button/PROG must be operated with
an insulated tool (1 KV electric strength).
Warning!
• Terminal connections must be carried out by an autho-
rised electrician.
• Only the back of the hand is protected by the device, no
protection against accidental contact.
Note: The i-R Receive Compact does not have a PROG-button.
1.)

Initial operation

1.1) Learn in the first transmitter

If a transmitter has not yet been learnt into the receiver, you can
programme any transmitter in the SELVE intronic range once the
power supply has been connected.
Important: Please connect only a receiver that has not learned
a trans mitter permanently to the power supply system.
a) i-R Receive
Press the PROG button of a programmed transmitter/channel or
i-R Receive for 3 seconds (wait for confirmation: brief upwards
and downwards movement of the motor). The receiver remains
in programming mode for 1 minute. Briefly press (1 sec.) the
PROG button of the new transmitter/channel. The new trans-
mitter/channel has now been programmed.
i-R Receive
3 sec.
new transmitter/channel
➡
33
1 sec.
✓
GB