Roco Z21 Mode D'emploi page 17

The module address can be set and firmware updates carried out under "Setup".
You can alter the occupied threshold and the delay durations for an occupied message or a vacant messa-
ge respectively. The Z21 detector can be used as a RailCom
nal 2 Daten an die Zentrale weiterleiten" (Forward Channel 2 data to the control centre) is activated. This
means that the POM reading also functions in sections in which a Z21 light booster is used, for example
The Z21 Maintenance Tool also includes the possibility of an R-BUS and LocoNet emulation under the
"CAN" tab. These makes it possible for you to use the Z21 detector in existing PC control systems without
this having the be expanded first. The Z21 detector is configured in the PC control system or in the Z21-
App as a Roco 10787 or as a LocoNet occupied detector.
Note: Please do not forget that each emulation generates additional occupied feedbacks so that
the possible Z21 Ethernet interface bandwidths are reduced. You should therefore only activate
the emulation you require.
8010808920.indd 17
local detector if the function "RailCom
®
D
Ka-
®
17 17
29.08.2017 11:51:42