Beta 960P Mode D'emploi page 4

Beta
ATTENTION
Working on fuel systems:
– use protective goggles, gloves and clothing
– make sure the room is well ventilated
– do not work with naked flames or sparking tools nearby
– do not smoke nearby
– in case of contact of fuel with eyes or skin, wash immediately and seek medical advice
Working on brake systems:
– use protective goggles, gloves and clothing
– keep to the instructions supplied by the brake fluid and system manufacturer
– use containers to avoid spilling brake fluid
– in case of contact of brake fluid with eyes or skin, wash immediately and seek medical
advice
Working on pressure sensors:
– keep to the instructions supplied by the manufacturer
– do not exceed maximum pressure as allowed by the sensor
Before each operating cycle, make sure that the tester is in good condition
Specifications:
Use:
Tester 960 P is designed to create and measure pressure and pressure vacuums in pipes, which
allows it to test the following:
– Pressure sensors of the fuel system
– Wastegate (overpressure) valves in turbo engines
– Electronic injection pressure regulating valves at low pressure
– Servo brakes
– Condition of the cylinder head and pistons (an engine in good condition results in a pressure
vacuum in the induction manifold, ranging from 0.5 bar to 0.7 bar)
To use the tester in the pressure vacuum mode, turn the knob to "IN" (Fig. 1); to use it in the
pressure mode, turn the knob to "OUT" (Fig. 2). The tester is fitted with a bar-psi gauge where you
can read the pressure/vacuum pressure value that has been created or measured.
INSTRUCTIONS
ART. 960P
Pressure/Depressure tester
GB