TFA 30.1009 Mode D'emploi page 5

TFA_No. 30.1009_usw_Anl_11_21
Indoor-outdoor thermometer
For your safety
• Keep this device and the battery out of reach of children.
• Small parts can be swallowed by children (under three
years old).
• Batteries contain harmful acids and may be hazardous if
swallowed. If you suspect a battery could have been swal-
lowed or otherwise caught in the body, seek medical help
immediately.
• Batteries must not be thrown into a fire, short-circuited,
taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to
prevent damage caused by leaking.
• Remove the battery if the device will not be used for an
extended period of time.
• Avoid contact with skin, eyes and mucous membranes
when handling leaking batteries. In case of contact, imme-
diately rinse the affected areas with water and consult a
doctor.
• Do not expose the device to extreme temperatures, vibra-
tions or shocks.
1. Getting started
• Pull the protective foil off the display.
8
06.11.2021 17:38 Uhr
Indoor-outdoor thermometer
• Open the battery compartment by pushing the cover in
direction of the arrow and remove the insulation strip.
• The display shows the current indoor and outdoor tempera-
ture.
• Slide the °C/°F switch at the back of the instrument to
change between °C (Celsius) or °F (Fahrenheit) as tempera-
ture unit.
2. Fixing
• Position the thermometer near a window using the built-in
hanging slot with a nail or a screw or unfold the table stand.
• Lead the cable with the sensing element through the open
window to the outside. The cable adapts to the window seal-
ing shape. (Take care of sharp-edged window frames – avoid
frequent opening and closing the window).
• Avoid radiators and direct sunshine.
3. Maximum and minimum values
• Press the MAX/MIN button and the highest and lowest
indoor temperatures are displayed since the last reset.
• Press the MAX/MIN button again, the display shows the
highest and lowest outdoor temperatures since the last
reset.
• To go back to the present temperature display, press the
MAX/MIN button once more. The instrument will automati-
cally quit the MAX/MIN mode if no button is pressed within
15 seconds.
Seite 5
9