Safety Instructions - Kermi BH200 Instructions De Montage

EN – Installation instructions
Permissible use
The brackets may only be used to install Kermi
steel panel radiators with a height of 200 mm.
Any other use is contrary to its intended pur-
pose and therefore not permissible.

Safety instructions

Read these instructions thoroughly prior to
►
installation.
DANGER
Danger!
Check the condition of the supply lines
►
(electricity, gas, water).
Do not drill into any of the lines.
►
WARNING
Risk of injury from spring mechanism!
Each bracket is held under tension by a
spring mechanism that releases when
pressed by the radiator.
Pretension brackets only after installa-
►
tion on the wall.
Do not take hold of the pretensioned
►
brackets.
WARNING
Personal injury and material damage!
Check substrate for load-bearing capac-
►
ity. Take the filled weight of the radiator
and possible additional loads into ac-
count (see manufacturer's data).
Check fasteners for applicability and tai-
►
lor them to the structural situation.
Take special requirements, e.g. for public
►
buildings (schools or the like), into ac-
count.
Disposal
Packaging and any parts that are not need-
►
ed should be recycled or disposed of prop-
erly. Observe local regulations.
Wall spacing
The space from the wall to the backside of the
heater is 25 mm.
Installation
Installing brackets (see Figs. 1–4)
Check fasteners for damage .
►
► Note the number of fastening points (see
Tab. A).
–
Identify the minimum quantity based on
the requirement class 1 – 3.
Note the number of fastening points (see
►
Fig. A, Tab. B).
Prepare tools.
►
Mark holes to be drilled.
►
–
Refer to the radiator's operating and
installation instructions for the radiator
dimensions.
Drill holes and insert wall anchors.
►
–
Do not drill with impact in cored clay tile
block.
–
Seat dowel into the wall up to the
flange.
T. 33: Pre-installing the brackets (Figs. a – c).
►
Screw on the brackets hand-tight.
►
Align brackets horizontally and vertically
►
and tighten screws.
Installing and securing the radiator
(see Fig. 5 – 8)
Pretension the brackets.
►
Place the radiator with the bottom edge on
►
the bracket foot and slide over the sound
insulation into the track, upright and press
in at the top.
► Check whether the spring mechanism has
latched at all brackets (visual inspection).
Ensure safeguard against shifting and lift-
►
ing due to tightening of the top screw.
ES – Instrucciones de montaje
Uso previsto
Las consolas sólo se pueden utilizar para el
montaje de radiadores planos Kermi con una
altura de montaje de 200 mm.
Cualquier otro uso se considera no conforme
con el fin previsto y, por tanto, está prohibido.
Advertencias de seguridad
Antes del montaje lea atentamente estas
►
instrucciones.
3