Krüger & Matz KM7089 Mode D'emploi page 21

Owner's manual
POwer SuPPLY
• This set works on normal household ac-power.
• Make sure the set voltage of the unit matches your local voltage.
• Insert the plug of the ac-cord into a wall outlet with ac-power.
• press the on/ STANDBY key to switch "on" the unit.
• This unit is designed to operate without ever being totally powered „off".It will
either be „on" or „STANDBY mode".
• In STANDBY mode, the blue BACK-light of the digital display will be switched off
but the display will show the current time (clock function).
• When in STANDBY mode, you can use the power switch (on remote control or
on front panel of the main unit) to switch „on" the unit.
• To conserve electricity, please switch the unit to „STANDBY mode" when not
listening to radio or CD music.
Important: when the power is "on" the entire digital display will be lit up witha
"blue" BACK-light. This indicates the hi-fi is switched "on".
Intelligent power saving system
1. This set has a built-in power saving system which will automatically put the set
into a „STANDBY mode" to reduce power consumption when it detects that the
set is not in use.
2. This automatic switching to „STANDBY mode" will happen approximately 10-15
minutes after the following circumstances:
• „CD" mode: CD playBACk has stopped (eg. At the end of a disc).
• „aux" mode: no input signal is detected at the aux input jack.
• „usb" mode: usb playBACk has stopped.
• „card" mode: sd card playBACk has stopped.
3. To re-activate the unit after it has automatically switched to „STANDBY mode",
simply press the „on/ STANDBY" key to switch the unit on.
Preparation of remote control
• Remove (gently pull out) the plastic „tab" from the battery compartment at the rear
of the remote control.
• Test the remote control by pressing the (on/ STANDBY) key to check that the unit
switches on properly using the remote control.
Connection of speaker boxes
• Unwrap the speaker-cords of both speaker-boxes.
• please notice that each speakers cord consists of 2 wires, one is „clear" and one
has a black line.
• Insert the „clear" wire of the left speaker-box into the „red" (+) speaker
connector beside the main-unit, which has the „l" indication (NEXT to the
speaker-connector).
• Insert the „black" wire of the left speaker-box into the „black" (-) speaker
connector beside the main-unit, which has the „l" indication (NEXT to the
speaker-connector).
• Repeat the above 2 steps for the „right" speaker box, but this time, inserting
them into the red & black connectors which have the „r" indication.
21