Kinderkraft VEO Guide D'utilisation page 35

To avoid injury ensure that the child is kept away when
unfolding and folding this product
Do not let the child play with this product
Check that the pram body or seat unit or car seat attachment
devices are correctly engaged before use
This product is not suitable for running or skating
Age and weight usage: from 0 months up to 15 kg
The product is designed to transport one child at a time. - Maximum basket load 2 kg. Any additional load suspended
from the buggy handles, under the backrest or on the sides will cause stability deterioration. Maximum weight of a bag
attached to the telescopic handle is 1 kg.
Lift the front suspension when going up a curb or step.
The brakes should be locked when the child is placed in or taken out of the buggy.
Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or accessories.
Do not place the product near open flame or other heat sources.
Do not use with an additional platform.
The following applies to the bassinet:
This product, in the form of a bassinet, is designed for children who cannot sit unaided, fall over or crawl using hands
and knees. Maximum child weight: 9 kg.
The bassinet must not be used as a child carrier. The bassinet handle is only designed for assembly and disassembly of
the buggy frame.
Do not insert an extra mattress apart from that supplied with the product.
The following applies to the stroller:
WARNING!
The seat is not suitable for children under 6 months old.
Always use the fastening system.
The product is intended for children from 6 months old to 15 kg.
Applies to Kinderkraft MINK car seat:
Kinderkraft VEO is available also as a set with a compatible Kinderkraft MINK car seat.
The product is intended for children from birth to 13 kg.
If the seat is used together with the buggy, it does not replace a cradle or crib. For sleep, place the child in the bassinet,
cradle or crib.
I Buggy components
A. Frame
B. Front wheels
C. Rear wheels
D. Rear axle with brake
E. Safety bar
II UNFOLDING BUGGY FRAME
Place the frame on a flat surface. To unlock, press the lock button on the telescopic handle and pull the mechanism (FIG.
1). Lift the handle up (FIG 2), unfold the frame until you hear the lock clicks (FIG. 3). To mount the rear axle with brake
(Part D), set the arm as shown in FIG. 4 and mount the axle (FIG. 5), until you hear the lock clicks. NOTE! After setting
the frame in its natural position, the brake lever should be on the side of the parent / telescoping handle.
III WHEEL ASSEMBLY/DISASSEMBLY
Insert the front wheels (part B) into the openings in the front of the frame, until you hear the lock clicks as shown in Figure
6A. To disassemble, push the quick release button (FIG. 6B). The buggy has front swivel wheels that may be locked for
travelling straight ahead. To lock the wheels for forward drive, press the button (FIG. 6C) until it locks and the wheel will
remain in a position to drive straight ahead. To unlock the wheels, press the button again. Insert rear wheels (Part C) into
the openings in the rear axle, until they lock (they should click) (FIG. 7A). To disassemble the rear wheels, press the lock
button and pull the wheels out of openings (FIG. 7B).
F. Seat/bassinet 2 in 1
G. Sunshade
H. Safety harness
I. Footmuff
J. Car seat adapters
35