Bycool Actros MP5 Mode D'emploi page 17

SLIM FIT
3
Position the unit on the seal, introducing the interior
distribution panel in the hatch gap.
Caution! When positioning the unit above the
hatch gap, check that the wastewater run-offs
are not blocked by the EPDM seal.
4
Screw (4) M8/125x26 hexagons with rubber
washer, flat washer in the base inserts, and tighten
with a torque of 12.7±10 Nm.
5
Position the fastening mounts with a flat washer,
grower washer and M8/125x45 screw, without
tightening.
Hatch
4
4
5
17
®
Base
Rubber washer
Flat washer
Hexagon M8/125x26
EN
3