Wiring And Setting Up - Tannoy CVS 4 Micro Mode D'emploi

7. Wiring and Setting Up

7. Wiring and Setting Up
1. Open the wiring cover at the back of the speaker can to access
the Euro-type connector plug and socket. (Fig.1)
2. For connection to an amplifier, use Pins 1 and 2 (Fig.2):
• Pin 1 is positive
• Pin 2 is negative
For connection to additional speakers in a distributed line,
Pins 3 and 4 are in parallel where:
• Pin 3 is negative
• Pin 4 is positive
3. Close the wiring cover and tighten both screws on the cable
clamp. Use the rotary switch located on the front of the unit to
select whether you wish to use the speaker in a low impedance or
distributed-line application.
THE SPEAKER IS SUPPLIED IN LOW IMPEDANCE MODE. NEVER
CONNECT THE SPEAKER TO A 70/100 VOLT AMPLIFIER WHILE IT
IS SET FOR LOW IMPEDANCE.
4. The CVS 4 Micro (EN54) is fitted with a 15 W transformer. When
used in distributed-line systems, the transformer can be tapped at
15 W, 7.5 W and 3.75 W, with an additional 1.9 W tapping for 70.7 V
line systems. (Fig.3)
10
CVS 4 Micro (EN54) Operation Manual rev 1.1.1
Fig.1
Fig.2
Fig.3