Roger Beep - PRESIDENT JOHNSON II USA Manuel D'utilisation

12) PTT
Transmission key, press to transmit a message,
and release to listen to an incoming communication.
14) CHANNEL SELECTOR UP on microphone
UP key (14) allows increasing a channel. A beep sounds
each time the channel changes if the KEY BEEP function
is activated (see KEY BEEP function below).
You can also use s key (4) on the unit.
15) CHANNEL SELECTOR DN on microphone
DN key (15) allows decreasing a channel. A beep sounds
each time the channel changes if the KEY BEEP function
is activated (see KEY BEEP function below).
You can also use t key (5) on the unit.

ROGER BEEP

Start the unit while pressing s (4) or UP (14) key to activate
the ROGER BEEP function. A beep sounds if KEY BEEP function
is on.
The icon " " appears on the display when the function is
active. The Roger Beep sounds when the PTT switch (12) of
the microphone is released in order to let your correspond-
ent speak. Historically as CB is a "simplex" communication
mode, it is not possible to speak and to listen at the same
time (as it is the case with a telephone). Once someone
had finished talking, he said "Roger" in order to prevent his
correspondent that it was his turn to talk. The word "Roger"
has been replaced by a significant beep. There comes
"Roger beep" from.
Note: the Roger beep also sounds in the loudspeaker if the
KEY BEEP function is active. If the KEY BEEP function is not
active, only the correspondent can hear the Roger Beep.
PA
In mode the function is not allowed.
is displayed
KEY BEEP
Beep on changing the channel, keys etc...
Start the unit while pressing t (5) or DN (15) key to activate
the KEY BEEP function. A beep sounds. "BP" is displayed.
Start again the unit while pressing t (5) or DN (15) key to
deactivate the KEY BEEP function. "BP" disappears.
MEMORY
This CB radio allows to memorize 3 channels with following
parameters: ANL (on/off), NB (on/off), HI-CUT (on/off).
To recall a memory:
- Short press •F/MEM key (6). If the KEY BEEP function is acti-
vated a beep sounds.
- Short press •M1 (9), •M2 (8) or •M3 (7) key to recall the
selected memory.
"MEM" and the number of the memory (1, 2 or 3) appears
on the display
To memorize:
- Select the channel and parameters to be memorized.
Short press •F/MEM key (6). If the KEY BEEP function is acti-
-
vated a beep sounds.
- Press •M1 (9), •M2 (8) or •M3 (7) key during 1 second to
store the selected channel into memory. "MEM" appears.
If the KEY BEEP function is activated a long beep confirms
-
the saving.
To delete a memory:
- Switch off the transceiver.
- Keep the memory key •M1 (9), •M2 (8) or •M3 (7) pressed
and switch on the transceiver.
The selected memory is deleted. "MEM" disappears.
-
12
(short press)
(long press)