PRESIDENT JOHNSON II USA Manuel D'utilisation page 10

is displayed. The scanning stops as soon as there is a busy
channel. The scanning automatically starts 3 seconds
after the end of the transmission and no key is activated
during 3 s. The scanning starts again in an increasing way
by pressing s (4) or UP (14) key, or in a decreasing way
by pressing t (5) or DN (15) key.
While scanning, press •F/MEM key (6) to alternate between
All Channel Scan and Memory Channel
Memory Scan Channel
In
and the memorised channels are scanned.
Press PTT switch (12), 9/19 key (7) , DW key (6) or long press
SCAN key (8) again to exit SCAN function.
WX MODE
Press and hold the SCAN key (8) for 1 second to activate
the SCAN function (for WEATHER channels) in an increas-
ing way. "SCAN" is displayed. The scanning stops as soon
as there is a busy channel. The scanning automatically
starts 3 seconds after the end of the transmission and no
key is activated during 3 s. The scanning starts again in
an increasing way by pressing s (4) or UP (14) key, or in a
decreasing way by pressing t (5) or DN (15) key.
Note: If the ALERT function is activated, the SIREN tone
sounds (see § ALERT below) when a tone is detected in the
selected WEATHER channel only. Use first SCAN function in
WX mode to detect tones in all the WEATHER channels.
A new long press on SCAN disables the SCAN function.
•M2
See § MEMORY page 12.
9) WX ~ ALERT ~ •M1
WX (WEATHER MODE)
CB functions are not allowed in
a not allowed key and KEY BEEP function is activated, the
radio sounds error tone.
Scan.
mode, channel 9, channel 19
(short press)
WX
mode. If user presses
Press WX key (9) in order to activate the
appears on the display. A new short press on WX key (9)
WX mode "WX" disappears.
disables the
WX
The mode allows to hear weather information. When
the mode is activated, use s/t key (4/5) or UP/DN key
(14/15) on the microphone to move through the 7 weather
channels to find the active channel in your local area.
The display shows the selected weather channel and if the
unit receives a signal, "WX" and "ALERT" icons blink.
ALERT
(long press)
The SIREN tone only sounds in
WX
sound in mode.
Press and hold the ALERT key (9) for 1 second to activate/
deactivate the ALERT function. When the function is on and
a tone is detected at the selected weather channel, then
the unit sounds SIREN tone. "ALERT" and the "WX channel"
blink on the display. The unit cancel
go to WX mode.
During a SIREN tone sound, press any key to stop the sound,
"ALERT" and the "WX channel" stop blinking on the display.
Note: The SIREN tone sounds when ALERT is detected in the
selected WEATHER channel only. Use first SCAN function in
WX mode (see § WX MODE above) to detect tones in all
the WEATHER channels.
•M1
See § MEMORY page 12.
10) CB/PA ~ LOCK ~ •VOX ~ •VOX SET
CB/PA
(short press)
Short press CB/PA key (10) to alternate between
PA
mode.
10
WX mode. "WX"
CB and PA mode. It does not
CB PA
or mode and
CB
and