About The Input Connectors On This Unit; Connection To Input1 And Input5 - Pioneer PDP-5004 Mode D'emploi

Installation and Connections
CAUTION
÷ Handles should not be removed or reattached by anyone other
than the professional installation technician or service
personnel.
÷ If handles must be removed due to specific installation
conditions, the mounting screws should be stored carefully
together with the handles. To ensure safety, the mounting
screws should be tightened to a minimum torque of 2N·m (20
kgf·cm) when reattaching the handles.
÷ When moving the display, it should always be carried by two
persons holding the rear handles in the manner shown.
NO!
÷ Never attempt to move the plasma display by holding only one
of the handles.
÷ When installing the plasma display, do not use the handles as
means of hanging the display; also do not use them as devices
to prevent tipping over (see illustration).
12
EN
About the Input Connectors on this
Unit
Consult the following chart when making connections to
a plasma display (pages 13 to 19).
Input Connector INPUT
Connected
*1
1
component and signals
Analog RGB
Component video
S-video
Composite video
Digital video
Analog RGB
S-video
Composite video
*1 Although INPUT1/INPUT5 are compatible with various kinds
of signals, setup using the on-screen menu is necessary after
connections are made in order match the characteristics of
the source component (pages 21 to 23).
*2 INPUT1 is compatible with Microsoft's Plug & Play (VESA
DDC 1/2B).
*3 Depending on the video output board of the computer, this
type of connection may not be possible.
*4 Although INPUT2 is compatible with various kinds of signals,
setup using the on-screen menu is necessary after
connections are made in order match the characteristics of
the source component (pages 23 to 24).

Connection to INPUT1 and INPUT5

Various components can be connected to the INPUT1 and
INPUT5 jacks. After connections are made, on-screen
setup is necessary to match the characteristics of the
connected component. Please see pages 21 to 23 for on-
screen setup after connection.
INPUT5 terminal
[ON SYNC]
Output source
Video component with
RGB output
G ON SYNC
Video component with
component video output
Note
When making connections to INPUT1, please refer to appendix 3
on page 49.
For the screen sizes and input signals that INPUT1
and INPUT5 are compatible with, please refer
to appendix 1 (page 46) and appendix 2 (pages 47
to 48).
INPUT INPUT INPUT INPUT
*4 *1
2 3 4 5
*2
*3
*3
C /P C /P
B B R R
Y
B R
Y C /P C /P
B B R R